CryptoPrevent v8.0.4.0 (May 24th, 2017)
- Fixed graphical issue with policy numbers applied being shown in the policy editor
- Added additional email settings CLI
- /emailusername=”user@addy.com”
- /emailsamesendtofromaddy
- or use the following together:
- /emailfromaddy=”user@addy.com”
- /emailsendtoaddy=”user@addy.com”
- or use the following together:
- /emailpassword=”password”
- /emailserver=”serverAddress”
- /emailport=”portNumber”
- /emailauthenable
- (Add =0 to disable)
- /emailstarttlsenable
- (Add =0 to disable)
- /emailsslenable
- (Add =0 to disable)
- /clientemailid=”Client ID to be added to Email Subject”
- /emaillocksettings
- (Add =0 to disable)
- Only applies to Bulk or White-Label Editions
- d7x Rule Variables now add environment variable as well as expanded paths
- Revised how SRP protection locations are handled
- Corrects issue where counts may have been off
- Corrects issue where same policy may have been added more than once from CLI options
- Added Debugging ability to the QuickAccess Notification Tray
- Currently debugging information is fairly limited but this will improve over new revisions if additional debugging information is required
- /debug when run from a command prompt with or without admin rights depending on the testing needed
- Improved Multi-User support for QuickAccess Notification Tray
- Bulk & White-Label Edition Installers Updated
- Waits for installation to complete prior to showing finished button on non-silent installations
- Silent installations wait on installers completion if being scripted now as well
- Fixed possible issues with systems not restarting after install when selected to do so from the Bulk-Creator
- Debug mode will be enabled by default on all Bulk Edition installs for the installation portion only
- This can be used to check for problems if something doesn’t work correctly in the Bulk Edition installation on a particular system
- Fixed possible issue with HoneyPot Detection triggering on changing of protections